Ambient Interior Lighting from £249
at SK Zone, 36 Upper Brook Street, Stockport · approx 6 hours
A finished install, after dark
Our own workOur own work, filmed in the unit. Door cards, dash line and footwells are each addressable separately — this is one car cycling through colours, not four different builds.
Registrations blurred. More of our work →
Fibre-optic and LED ambient lighting installed the proper way: trim panels out, cable run behind the trim and down the loom, tapped into a switched ignition-live rather than dangling off a cigarette socket, and every join soldered and heat-shrunk. Choose your zones — footwells, door cards, dashboard line, centre console, cupholders, boot — pick static colours or a mode, and control it from an app or a hidden switch. Configure the whole thing on our ambient studio page and you will see the exact combination on screen before you book. We keep the light off the windscreen and out of your night vision, and we do not fit anything that shows red to the front or white to the rear.
Estimate only — the final price is confirmed once we have seen the car. Nothing is charged online.
Price it properly first
The build tool gives you a figure for your exact car, and you can stack this with anything else.
Common questions
Is interior ambient lighting legal?+
Interior lighting is fine as long as it does not dazzle you or other drivers and does not show red to the front or white to the rear of the vehicle. Blue is reserved for emergency vehicles where it is visible externally. We fit to those rules and keep the light behind the trim line where it belongs.
Will it drain my battery?+
No. We wire it to a switched ignition live so it dies with the car, and the whole install draws a couple of amps at most.
Can I control it from my phone?+
Yes — the controllers we fit pair over Bluetooth for colour, brightness and modes, and we can add a hidden physical switch as well so it works with the phone in your pocket.
Will you cut my trim?+
The fibre optic sits in the existing panel gaps — no cutting on a standard install. If a design does need a channel we will show you exactly where before anything is touched.